Features

• 65mm diagonal, squished X geometry, for 31mm props
• 1.5mm Carbon Fiber / Individual Nylon ducts hybrid construction
• Low-profile camera mount, no props in view, no tilt offset
• Low Center of Gravity, by bringing the AIO closer to the frame/motors
• Allows mounting with USB pointing up for easy accelerometer calibration
• No need for a canopy as all electronics are tucked safely between the ducts
• Maximum rigidity where it matters most; connecting the motors to the FC
• Easy maintenance, break one duct, replace only the single duct
• Lightweight, less than 19.5g with HM DiamondF4
• As always, this is a project that Fractal designed for himself first, that Fractal put together in a product to share with any pilot that would like to experience the same level of requirements!
• Designed with love, by a pilot, for pilots.
• This frame kit contains everything you need to build your own craft, based off virtually any components.
• Fractal do however recommend a 4-1 AIO (FC/ESC/RX/VTX) to keep the part count to a minimum, but there should be enough room to stack a separate VTX or RX on top of the AIO
• It has a 25.5×25.5mm mounting pattern for the AIO, and motor fixations for both 3xM1.4×6.6mm and 3xM1.6×5.5
• The camera mount is 3D printed and universal – Fractal will upload the STL and Step files so you may print your own spares or season them to taste

Contents

• 1x Fractal 65 Base Plate
• 1x Nylon frame (used by trimming the ducts off)
• 2x Printed TPU fixations (camera, front and rear battery mounts)
• 14x M1.4x5mm steel machine screw for motors
• 4x M1.7x5mm self-threading screw for short board grommets
• 4x M1.7x7mm self-threading screw for long board grommets