TBS partnered with Zeez to make this awesome whoop AIO. Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..

The FC weighs 7.6g and is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and longrange cruiser like the TBS Aureo. 

FC side

• Mounting holes: 25.5×25.5 mm / M2 holes
• Crossfire/Tracer RX CH1&2 > Uart 2  /  Pro32 Nano VTX > Uart 1 / Uart 1(RX) - unavailable.
• Up to 6S input
• 5V BEC up to 1.2A continuous
• STM32F411 MCU (Support BetaFlight, EmuFlight)
• MPU6000 Gyro/ACC
• OSD chip Onboard (AT7456E)
• 2 available UART
• LC Filter for 5V VTX and Camera
• Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
• Support programmable LED like WS2812 etc
• Built-in current sensor
• Weight: 7.6g 

ESC side

• Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
• Input voltage: 2S-6S Lipo
• Continuous current: 30A
• Peak current: 35A
• ESC firmware: BLHELI 32
• PWM Frequency Range: 24KHz up to 96KHz

GPS Installation

Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. 
Note: The following steps will disable LED and FC's SmartAudio and use as softserial for GPS.  

        1. Flash the board with Target: STM32F411

        2. Download the Config file [HERE]. Then load it the board. 

        3. Wire the GPS as shown 

Includes

• 1 x TBS Podracer AIO 
• 1 x Capacitor 
• 1 x AWG cables set with shrink tubes
• 4 x mounting gromets
• 1 x XT60 (Male)
• 1 x XT30 (Male)
• 1 x Pinheaders set for TBS VTX and RX