Team BlackSheep Online Store - HobbyWing XRotor Micro ESC&FC F4 G2 Combo
Forgot Password
8-20 characters, no space
Your cart is empty.

HobbyWing XRotor Micro ESC&FC F4 G2 Combo

US$ 77.77

Delivery time: In stock

FC Features

  • Redesign every aspect STM32 F405 MCU allows the FC to run the PID looptime and gyro with higher frequency.
  • The SPI ICM-20602 which integrates accelerometer and gyro (with the running frequency can be set to 32KHz) is adopted.
  • Onboard OSD microchip which supports the DMA mode allows users to adjust its parameters via the Betaflight software. (Note: the OSD is controlled by the F4 MCU.)
  • The FC which supports Betaflight firmware & allows parameter adjustment via Betaflight software is more applicable to FPV race.
  • F-card which can record and save more flight/black box data allows users to adjust thesetup of their aircraft easily.
  • Compatible with various receivers like SBUS, SUMH, SUMD, SPEKTRUM1024/2048, XBUS, PPM and etc.
  • LED strip signal output port allows users to adjust the color & flash mode of the LED strip via the FC.
  • Volt/Amp monitoring port allows users to check the battery voltage (BAT port) and current (CRT port , extra current meter is needed).
  • Buzzer output port allows users to connect external buzzer(s) to the FC for warning or informing the flight status of the aircraft.
  • Micro USB port allows users to connect the FC to a PC to flash firmware and adjust parameters. 

FC Specification

  • Model: Micro F4 Flight Controller F4 G2 + OSD
  • Application: FPVs with 130-300mm FPVs Diagonal Wheelbase
  • Firmware: OMNIBUSF4SD
  • FC Programming: supported
  • Programming via: Betaflight/Cleanflight-configurator or Others
  • Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc
  • Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL, and etc.
  • OSD: Buit-in
  • Voltage Monitoring: Supported
  • Current Monitoring: Supported
  • External Buzzer: Supported
  • LED Control: Supported
  • USB Port: MicroUSB
  • Timing: Supported
  • Motor Rotation: Supported
  • size/ weight: 36*36mm / 6g

ESC Features

  • High performance 32-bit microprocessor with the running frequency of up to 48MHz for excellent performance.
  • BLHeli_32 firmware is the third generation BLHeli, following base BLHeli and BLHeli-S.
  • All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling.
  • The code supports features to prevent sync loss. There are tunable parameters that can make the code run well even in the most demanding situations, although default settings will work excellently in normal operating environments.
  • The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
  • Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power up.
  • The code also supports a beacon functionality, where the ESC will start beeping after a given time of zero throttle. This can be very useful for finding lost crafts.
  • On board 10V &5V BEC , powering different accessories such as FC , VTX ,Camera and LED lights and etc. 

ESC Specification

  • Model: XRotor Micro 45A 4in1 BLHeli32 6S
  • Application: FPVs with 130-280mm Diagonal Wheelbase
  • LiPo Power input: 3S-6S
  • Cont.Current: 45Ax4
  • Burst Current: 60Ax4
  • BEC Output: 5V@1.5A / 10V@1.5A
  • Input wires: 12AWG-130mm* (Red/Black)
  • Output Wire: No wires but solder tabs
  • Connectors(In/Out): XT60 (w/ Wires Soldered on) /no 
  • Weight / Size: 11.5g / 32.7x18.4x6.2mm
  • Mounting holes: 30.5x30.5mm
  • Throttle Calibration: Supported
  • ESC Programming: BLHeliSuite32
  • DEO: Supported
  • OneShot Mode: Supported
  • Timing: Supported
  • Motor Rotation: Supported



US$ 77.77