The ultimate F7 racing FC, made by racers. Never worry about adding LEDs to your drone for FAI races. Connect up to 40 LEDs directly to the 4 corners of the FC and control output colours directly from betaflight.
[Manual]
Specifications:
-
Size: 20*20 M3 holes with vibration damping
-
MCU: STM32F722RET6 216MHz
-
Gyro: MPU6000 6-Axis
-
Input: Up to 12S (50V) direct battery power Yes! 12S!
-
USB type C
-
DJI direct plug (6 pin)
-
VTX pit mode switch - configured in Betaflight modes
-
5V or VBAT selectable for VTX and CAM power
-
One wire Analogue Camera Control
-
4 Led pads (one at each corner) for easy LED installation - up to 40 LEDs on white and 100 LEDs in colour - perfect for FAI international races - shares 5V with 5V/2A BEC
-
6 UARTS, 4 full UARTS with RX AND TX pins
-
8 pin 4 in 1 ESC plug
-
M5, M6 pads for additional motor outputs
-
Buzzer pads for external buzzer
-
Built in Betaflight OSD
-
Boot button
-
Logical pin layout for cleanest build
*Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
vtx pit switch cant control the dji plug
Package Included:
-
1x Wizz F7 HD 20x20 Flight Controller
-
6x M3 vibration damping
-
1x SH1.0 8PIN Cable (60mm) one side open ended
-
1x DJI Air Unit Cable (40mm)